Installation; Installation Using Included Yoke Bracket - Tannoy AMS Series Operation Manual

Surface mount loudspeakers

Hide thumbs Also See for AMS Series:

Table of Contents

5. Installation

1. Fix the yoke bracket to an appropriate structural surface using a suitable fixing method.

2. Remove the yoke trims from the product to access the bracket fixing points.

3. Set the transformer tap as detailed in Section 6 following.

4. For indoor installation (proceed to step 5 for outdoor installation): Connect the euro-style plug to the wires,

observing correct polarity. Use pins 1(+) and 2 (-) for connection of the loudspeaker. Use pins 3 (-) and 4 (+)

for connection of additional loudspeakers in a distributed line. NOTE: Tighten pins 3 and 4 even if not used to

prevent vibration of the screws.

5. For outdoor installation: Feed the loudspeaker wire(s) through the opening in the neck of the cable entry

cover included with the product.

Connect the euro-style plug to the wires, observing correct polarity. Use pins 1(+) and 2 (-) for connection of the

loudspeaker. Use pins 3 (-) and 4 (+) for connection of additional loudspeakers in a distributed line.

NOTE: Tighten pins 3 and 4 even if not used to prevent vibration of the screws.

6. Place the loudspeaker inside the yoke bracket. Position buffers between bracket and loudspeaker as shown.

Attach with supplied fixings using a 5mm Allen key. Use the longer hex screws supplied when mounting the

yoke bracket.

AMS Series Operation Manual rev 1.1.0

Table of Contents

Show Quick Links

Table of Contents