Fieldbus Connection - Datalogic matrix 450N Reference Manual

5

5.3 FIELDBUS CONNECTION

In this layout a single reader functions as a Slave node on a Fieldbus network. The data is
transmitted to the Host through an accessory Fieldbus interface board installed inside the
CBX500 connection box.
Reader configuration can be accomplished through the Ethernet interface using the
DL.CODE configuration program.
Data can be transmitted on the RS232 auxiliary interface independently from the Fieldbus
interface selection to monitor data.
When One Shot or Phase Mode operating mode is used, the reader can be activated by an
External Trigger (photoelectric sensor) when the object enters its reading zone.
Power
Matrix 450N
Alone
CAB-LD-102
All devices always support multiple output channels (i.e. for data monitoring).
80
CAB-MS0x
2
3
Figure 56 – Fieldbus Interface Point-to-Point Layout
MATRIX 450N™ REFERENCE MANUAL
CBX500 + Fieldbus Module
Fieldbus Host
1
 Fieldbus Interface (Profibus, DeviceNet, etc.)
 Auxiliary Serial Interface (RS232 - Data Monitor)
 External Trigger (for One Shot or Phase Mode)