Selecting The Interface Type; Interface Selection; Configuring The Interface - Datalogic Gryphon GD44XX Quick Reference Manual

Selecting the Interface Type

Selecting the Interface Type
Upon completing the physical connection between the
reader and its host, proceed directly to Interface Selection
below for information and programming for the interface
type the reader is connected to (for example: RS-232, Key-
board Wedge, USB, etc.) and scan the appropriate bar code
to select your system's correct interface type.

Interface Selection

Each reader model will support one of the following sets
of host interfaces:
General Purpose Models —
board Wedge, Wand.
Retail Point of Sale Models —
IBM 46XX.
Information and programming options for each interface
type are provided in this section. For defaults and addi-
tional information associated with each interface, proceed
to the corresponding chapter in the Gryphon™ 4400 PRG.

Configuring the Interface

Scan the appropriate programming bar code to select the
interface type for your system.
4
Unlike some other programming features and
options, interface selections require that you
scan only one programming bar code label. DO
NOT scan an ENTER/EXIT bar code prior to
scanning an interface selection bar code.
Some interfaces require the scanner to start in
the disabled state when powered up. If addi-
tional scanner configuration is desired while
in this state, pull the trigger and hold for 5
seconds. The scanner will change to a state
that allows programming with bar codes.
RS-232, RS-232 OPOS, USB, Key-
RS-232, RS-232 OPOS, USB,
PowerScan™ Retail PBT9500-RT