Table of Contents
Advertisement
5. FIRMWARE DOWNLOAD
Firmware upgrade procedure
Step 1: Disable Low Power Mode:
Please turn on the projector and manually set the Low Power Mode to Off,
(Settings 2 -> Advanced 1 -> Low Power Mode -> Off)
Turn off the projector.
After a brief cooling period, please proceed the regular firmware download procedure.
Step 2: Make sure that the USB cable(USB-A to USB-B type) is firmly connected between
projector and computer.
Step 3: In STAND BY mode press <Down>, <Up>, <Right>, <Up> key by IR remote controller.
The "Lamp" LED will blink and the Flash-Tool mode will be enabled.
Step 4: Use Composer Lit to upgrade the flash.
Note: Please make sure the setting in Communications as bellow picture.
37
Advertisement
Table of Contents
