Table of Contents
Advertisement
10-4. Cleaning the DMD
The DMD surface is glass and can be cleaned. However, avoid scratches as these can
have a direct influence on the image.
In case of dust on the DMD surface use an air cleaner ( with a device to prevent static, if
possible) to clean off the surface.
In case of fingerprints, etc., add a small amount of water to the designated glass cleaner
and wipe off in one direction. Then use the designated dry glass cleaner to wipe off in the
same direction.
Caution:
Do not use absolute alcohol or other substances that could leave streaks after drying.
10-5. Cleaning the Main Unit
Clean with a soft fuzz-free cloth. In case of severe soiling, use a well-wrung cloth dipped
in a neutral agent to remove soiling and then finish with a dry cloth.
Do not clean with thinner, benzene or similar agents as this could lead to deterioration or
peeling of paint.
In case of dust in suction or exhaust holes or the interior, disassemble the main unit and
use air to remove the dust from the inside.
54
Advertisement
Table of Contents
