Table of Contents
Advertisement
Removing SAS (ENC) cables
After removing power cables, use the following procedure to remove the
SAS (ENC) cables.
1. For all Drive Boxes other than the DBX, remove the SAS (ENC) cable by
gently pulling the tab of the SAS(ENC) cables connecting the chassis.
2. For the DBX Drive Box:
a. Open the cable routing bar and remove the cable holder to which the
SAS (ENC) cable is connected.
b. Loosen the blue screws securing the holder cover of the cable holder,
and then remove the holder cover.
c. Gently pull the tab of the SAS(ENC) cable to remove the cable.
d. Pull the screws of the stopper in the direction of arrow
6 on page 15-22
Figure 15-4: SAS (ENC) cable
Figure 15-5: Removing the holder cover
and remove the cable routing from the rails.
Upgrading a Hitachi Unified Storage 130 system
Hitachi Unified Storage Hardware Service Guide
in
Figure 15-
?
15–21
Advertisement
Table of Contents
