Removing A 3.5-Inch Hard Drive - HP ProDesk 405 G1 Microtower Maintenance And Service Manual

5.
If installing a USB 3.0 media card reader, connect the media card reader 3.0 cable to the USB
3.0 to USB 2.0 adapter (1) and connect the adapter to the connector on the system board labeled
MEDIA (2).
NOTE:
drive connectors.

Removing a 3.5-inch hard drive

NOTE: Before you remove the old hard drive, be sure to back up the data from the old hard drive so
that you can transfer the data to the new hard drive.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Disconnect the power cable and data cable from the back of the hard drive.
Refer to System board connections on page 38
(Access panel on page
for an illustration of the system board
(Preparation for disassembly on page
27)
26)
Drives
47