DYNACO PAT-4 Assembly Manual page 23

5. Separate and twist the drain wire.
6. Peel back and remove the foil. Remove the plastic wrap from the red and black
wires. The drain (bare wire), red, and black wires are exposed now that gray
insulating jacket, foil shield, and plastic over-wrap have been removed.
7. To make a shielded cable for a right channel application, pull the black wire out
of the shielded cable and leave the red wire for RIGHT channel signals.
8. To make a shielded cable for a LEFT channel application, pull the red wire out of
the shielded cable and leave the black wire for LEFT channel signals.
9. Slip about half of the gray outer jacket you removed in the first step over the drain
wire. This will keep the bare drain wire from contact something by accident.
10. Remove 3/8" of insulation from the red wire. Twist its strands tightly. Twist and
tin the ends of the red wire and the drain wire.
Page 23 of 23