Chicco 06626 Instructions For Use Manual page 35

the indicator light (8) will light up
green and begin to flash. At the same
time on the display (4) that the im-
age of the baby disappears, the icon
appears and, after about 10 seconds,
2 consecutive beeps per second are
heard.
As soon as the link is restored, the
beep will switch off and the display (4)
will show the icon and the indicator
light (8) will light up steady green.
NOTE: when the parent unit switches
on, it searches for the channel to link
with the Baby unit; therefore the indi-
cator light (8) will flash green and the
display will show the icon
is established.
-Indication of device off:
the indicator light (8) will switch off.
• The rechargeable lithium-ion battery
status indicator light (9) supplies 3 dif-
ferent pieces of information:
-Indication that the rechargeable bat-
tery (13) is almost flat: the indicator
light (9) will light up red and begin to
flash. At the same time on the display
(4), the battery flat icon appears and
a beep is heard each second.
If you want to continue using the
device, it is advisable to charge the
rechargeable lithium-ion battery (13);
otherwise, the device will stop work-
ing. Charge the rechargeable lithium-
ion battery (13) by connecting the
mains adapter (1) to the parent unit
power and charger connector (14).
When charging starts, the beep will
switch off.
-Indication that the rechargeable bat-
tery (13) is charging: when charging
begins, the indicator light (9) switches
on steady red and the display shows
the icon of a battery with its internal
notches switching on in succession.
Leave the battery to charge until the
indicator light (9) switches off and
•
until the icon
steady.
The parent unit can still be used to
monitor the baby while the recharge-
able battery is charging, but the time
required to reach full charge will be
longer.
-Indication that the rechargeable
battery is charged or of operation via
mains adapter (1) without recharge-
able battery:
the indicator light (9) will switch off.
•
until a link • Lit level indicator bar for sounds
emitted by the baby (3):
Illuminates progressively from the
centre outward, indicating 3 levels of
sound intensity coming from the Baby
unit (primarily in transmitter mode of
images and sounds) microphone (6)
Allows parents to monitor sounds
emitted by the baby even when the
parent unit loudspeaker volume is
switched off.
if sounds emitted by the baby are of a
relatively low intensity.
emitted by the baby are of medium
intensity.
emitted by the baby are of a relatively
high intensity.
Attention: After switching on the par-
ent unit (primarily in receiver mode of
images and sounds) always check the
power status of the Baby unit (primar-
ily in transmitter mode of images and
sounds)!
After switching on the unit, always
check that reception of the transmit-
35
on the display remains
: the central LED lights up
: 3 LEDs light up if sounds
: 5 LEDs light up if sounds