Toshiba RAS-10JKVP-E Service Manual page 9

Appendix
No. Photo / Explanatory diagram
1-5
1-6
Valve fixing plate
1-7
1-8
Motor base
assembly
Sound
insulation board
Partition plate
assembly
Heat exchanger
Compressor
3 positions
Appendix-4
Procedure
Remove the motor base and the sound insulation board.
Related parts / Screws list
Part name
Motor base assembly
(Including motor and fan)
Remove the partition plate assembly.
Related parts / Screws list
Part name
Partition plate assembly
(Including reactor)
Remove the fixing screws of the heat exchanger and the
valve fixing plate. Remove the compressor fixing nut.
Related parts / Screws list
Part name
Heat exchanger
Valve fixing plate
Compressor
As shown in the left figure, remove the set of refrigeration cycle
assembly from the outdoor unit base.
* In this time, work attentively so that the cycle pipes are not
damaged by dent or deformation. Apply protective
measures to pipes if necessary.
Used screw
Screw type Quantity
Ø4 × 10 2
Used screw
Screw type Quantity
Ø4 × 10 3
Used screw
Screw type Quantity
Ø4 × 10 1
Ø4 × 10 2
Ø8 nut 3