Transportation Methods; User Responsibility; Fabricator 181I Portable System Package (Part No. W1003181) - ESAB Fabricator 181i Service Manual

3-in-1 multi process welding systems

Hide thumbs Also See for Fabricator 181i:

Table of Contents

ESAB FABRICATOR 181i

2.05 Transportation Methods

WARNING

Disconnect input power conductors from de-energized supply line before moving the welding

Power Source.

Lift Power Source with handle on top of case. Use handcart or similar device of adequate capacity. If using a fork

lift vehicle, secure the Power Source on a proper skid before transporting.

This equipment will perform as per the information contained herein when installed, operated, maintained and

repaired in accordance with the instructions provided. This equipment must be checked periodically. Defective

equipment (including welding leads) should not be used. Parts that are broken, missing, plainly worn, distorted

or contaminated, should be replaced immediately. Should such repairs or replacements become necessary, it is

recommended that such repairs be carried out by appropriately qualified persons approved by ESAB. Advice in

this regard can be obtained by contacting an Accredited ESAB Distributor.

This equipment or any of its parts should not be altered from standard specification without prior written approval

of ESAB. The user of this equipment shall have the sole responsibility for any malfunction which results from

improper use or unauthorized modification from standard specification, faulty maintenance, damage or improper

repair by anyone other than appropriately qualified persons approved by ESAB.

INTRODUCTION

2-2

A-12920

Manual 0-5449

Table of Contents