Table of Contents
Advertisement
Engine
DO NOT service this unit while it is running. The
high-speed mechanical parts as well as high
temperature components may result in severe
injury, severed limbs, or fatality.
NOTE: Use the hour meter as a guide for
coordinating the maintenance schedule.
1. Check the engine oil level daily. Make certain that
proper oil level is maintained. NEVER overfill.
2. Change the break-in oil and filter after the first 25
hours of operation. Thereafter, change oil and filter
every 100 hours of operation (regular oil) or 150
hours of operation (synthetic oil). Use only
approved ZPP416 filters.
Oil Recommendation. Use high-quality detergent oil of
at least API (American Petroleum Institute) service
class SH. The recommended SAE viscosity grades are
10W-40 or 15W-40 for regular oil. Recommended
viscosity grades for synthetic oil are 10W-30, 10W-40,
15W-50 and 20W-50.
NOTE: Using less than service class SH oil or
extending oil change intervals longer than
recommended can cause engine damage.
Engine oil capacity is approximately 3.5 quarts
(3.3Liters) including filter.
3. Check the air cleaner element every 250 hours.
Replace the element annually.
4. Check the coolant level in the radiator overflow
container daily. If no coolant is seen, remove the
cap and add coolant. Change the coolant with a
50/50 coolant to water ratio every 1000 hours or 2
years.
5. Replace the in-line fuel filter under the vehicle
every 1500 hours.
NOTE: For additional engine service information,
obtain a "ZPP416" service manual from any
authorized Zenith Power Products Service Center. If
service or repair is required, contact an authorized
Zenith Power Products Service Center. You will need
to provide the serial number of the engine.
86352170 EVEREST
Maintenance
43
Advertisement
Table of Contents
