Pre-Run Inspection / Setup; Water Supply Connection; High Pressure Solution Hose; Vacuum Hose - Prochem EVEREST 650 Operating Instructions Manual

Everest 650 high pressure 1.001-145.0 everest 650 low pressure 1.001-146.0 everest 408 high pressure 1.001-151.0 everest 408 low pressure 1.001-152.0
Hide thumbs Also See for EVEREST 650:
Table of Contents

Advertisement

Operations

Pre-run Inspection / Setup

NOTE: Operation of this unit is simple. However, only
trained personnel should proceed.
Operate this unit and equipment only in a well-venti-
lated area. Exhaust fumes contain carbon monoxide,
which is an odorless and deadly poison that can cause
severe injury or fatality. DO NOT operate this unit
where the exhaust may enter any building doorway,
window, vent, or opening of any type.
Check For Adequate Fuel
Check the fuel tank to be certain there is adequate fuel
to complete the job. This unit uses approximately 1.00
to 1.50 gallons of fuel per hour, depending on the
speed setting and vacuum load.
Remove Tools from Vehicle
Remove any tools or hoses from the van which you will
require.

Water Supply Connection

NOTE: Before connecting your water hose to the
supply faucet, flush out the faucet until the water is
free of any debris. Flush out any debris that may be in
your water inlet hose.
1. Connect the water supply hose to the water inlet
quick-connect at the left front of the console.
Connect the hose to the water supply faucet.
NOTE: Never use your waste pump outlet hose as a
water inlet hose. Use only clean hoses for water inlet.
2. Turn the water supply faucet on. The water will fill
the water box.
Don't run the solution pump dry, damage may
occur and void the warranty.
In the event the pump is run dry, allow the pump to
cool down to ambient temperature before reintro-
ducing water. Otherwise major damage may occur
and void the warranty.
34

High Pressure Solution Hose

Before starting the unit, connect the high-pressure
solution hose to the outlet connection at the front of the
unit. Connect the cleaning tool to the pressure hose.
DANGER
WATER UNDER HIGH PRESSURE AT HIGH
TEMPERATURE CAN CAUSE BURNS,
SEVERE PERSONAL INJURY, OR COULD
BE FATAL. SHUT DOWN MACHINE,
ALLOW TO COOL DOWN, AND RELIEVE
SYSTEM OF ALL PRESSURE BEFORE
REMOVING VALVES, CAPS, PLUGS,
FITTINGS, FILTERS AND BOLTS.

Vacuum Hose

Connect the vacuum hose to the vacuum inlet connec-
tion at the front of the Filter Box. Connect the other end
of the vacuum hose to the cleaning tool.
Filters
Ensure all filters on machine and in waste tank are free
of debris.
86352170 EVEREST
ROTATING
DANGER
MACHINERY.
WATER UNDER
PRESSURE AT HIGH
DO NOT MODIFY
TEMPERATURE.
UNIT WITHOUT
IMPROPER
MODIFICATION OF
WRITTEN
EQUIPTMENT CAN
PERMISSION
CAUSE SEVERE
FROM
PERSONAL INJURY
MANUFACTURER
OR COULD BE
FATAL.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Everest 408

Table of Contents