Replacing The Solid-State Drive; Procedure - Dell XPS 13 Service Manual

Replacing the solid-state drive

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
CAUTION: Solid-state drives are fragile. Exercise care when handling the
solid-state drive.

Procedure

1 Align the notches on the solid-state drive with the tabs in the solid-state drive
slot, slide the solid-state drive at an angle into the solid-state drive slot, then
press the other end of the solid-state drive down.
2 Align the screw holes on the hard disk plate with the screw holes on the system
board.
3 Replace the two screws (M1.6x2.5) that secure the hard-disk plate to the
system board.
computer. After working inside your computer, follow
After working inside your computer. For more safety best
www.dell.com/
Before
19