Makita DFS250 Instruction Manual page 8

Installing or removing driver bit/
socket bit
For DFS250
1
Fig.11
► 1 . Locator
2
Fig.12
► 1 . Locator 2. Driver bit 3. Magnetic bit holder
To remove the driver bit, pull the locator, and then grasp
the bit with a pair of pliers and pull the bit out of the
magnetic bit holder. To install the driver bit, push it firmly
into the magnetic bit holder. Then install the locator by
pushing it firmly back.
For DFS251
1
Fig.13
► 1 . Locator
Fig.14
► 1 . Locator 2. Socket bit
To remove the socket bit, pull the locator, and then pull
the socket bit. To install the socket bit, push it firmly into
the sleeve. Then install the locator by pushing it firmly
back.
1
3
Fig.15
► 1 . Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
8 ENGLISH
Hook
1
2
3
1
2
1
2
3