7 Use Bluetooth
devices
With this car audio system, you can listen to
audio from a player or make a call through
Bluetooth.
Connect a device
Note
•
Gibson Innovations does not guarantee the
compatibility with all Bluetooth devices.
•
Before pairing a device with this system, read its user
manual for Bluetooth compatibility.
•
Make sure that Bluetooth function is enabled on your
device, and your device is set as visible to all other
Bluetooth devices.
•
At one time, you can connect only one Bluetooth
device to this system.
•
The operational range between this system and a
Bluetooth device is approximately 3 meters (9 feet).
•
Any obstacle between this system and a Bluetooth
device can reduce the operational range.
•
Keep away from any other electronic device that may
cause interference.
On your device, follow the steps below.
1
Search for Bluetooth devices.
2
In the device list, select CE235BT.
» If the pairing succeeds, [PAIRED] is
displayed on the LCD screen of this
system.
» If the connection succeeds,
[CONNECTED] scrolls and
displayed on the LCD screen of this
system.
» If the connection fails, [FAILED] is
displayed on the LCD screen of this
system.
If a password is required, enter 0000,
•
and then confirm the password
entry. For some devices, you need to
enable or permit the connection with
CE235BT after successful pairing.
16
EN
Disconnect a device
1
Press and hold
menu.
2
Press
is displayed.
3
Press
» [WAIT] is displayed with -, --,
•
You can also complete the disconnection on your
device.
Reconnect a device
Some Bluetooth devices support the automatic
reconnection with a paired Bluetooth device.
If your device does not support automatic
reconnection, reconnect it with this system
manually.
1
Press and hold
menu.
2
Press
displayed.
3
Press
» [WAIT] is displayed with -, --,
is
» If [CONNECTED] scrolls, this system
•
You can also complete the reconnection on your
device.
to access the system
/
repeatedly until [DIS--CON]
.
and --- blinking alternately until
[DISCONNECTED] scrolls.
Tip
to access the system
/
repeatedly until [RE-CON] is
.
and --- blinking alternately until
[CONNECTED] scrolls or [FAILED]
appears.
is reconnected to the last connected
device.
Tip