Connect Wires - Philips CE235BT User Manual

Hide thumbs Also See for CE235BT:
Table of Contents

Advertisement

Connect wires

Note
Make sure that all loose leads are insulated with
electrical tape.
Consult a professional to connect wires as instructed
below.
1
Check the car's wiring carefully and
connect them to the ISO male connectors.
ISO male
Connect to
connectors
a
Green strip, black-
Rear left speaker
edged green strip
b
White strip, black-
Front left speaker
edged white strip
c
Gray strip, black-
Front right speaker
edged gray strip
d
Purple strip, black-
Rear right speaker
edged purple strip
e
Red strip
Ignition key +12V
DC when ON/
ACC
f
Blue strip
Motor/electric
antenna relay
control lead
g
White-edged blue
Amplifier relay
strip
control lead
h
Black strip
Ground
ISO male
Connect to
connectors
i
Yellow strip
To the +12V car
battery which is
energized at all
times
2
Connect the antenna and amplifier as
illustrated, if applicable.
e
f
L
REAR
R
d
c
b
a
Sockets on rear
External sockets or
panel
connectors
1
For ISO male
As indicated above
connectors
REAR L
2
Rear left speaker
REAR R
3
Rear right speaker
ANTENNA
4
Antenna
5
Purple strip
OE remote control
module
6
Black strip
Ground
Tip
The pin arrangement for the ISO connectors depends
on the type of your vehicle. To avoid damage to the
unit, connect properly.
EN
Page 7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents