Configure Acl Control Over The Http Users; Define An Acl; Call Acl To Control Http User - Huawei Quidway S5000 Series Operation Manual

Operation Manual - QoS/ACL
Quidway S5000 Series Ethernet Switches

3.4 Configure ACL Control over the HTTP Users

Huawei Quidway Ethernet switch series support the remote management through
WEB. The users can access the switch through HTTP. Controlling such users with ACL
can help filter the illegal users and prevent them from accessing the local switch. After
configuring ACL control over these users, the switch allows only one WEB user to
access the Ethernet switch at one time.
Take the following steps to control the HTTP users with ACL.
1)

Define an ACL

2) Call ACLs to control the HTTP user
The follow section introduces the configuration procedures.
3.4.1 Define an ACL
So far, you can only call the numbered basic ACL, ranging from 2000 and 2999, to
implement ACL control function. Use the same configuration commands introduced in
the last section.

3.4.2 Call ACL to Control HTTP User

To control the WEB network management users with ACL, call the defined ACL.
You can use the following commands to call an ACL.
Perform the following configuration in system view.
Table 3-4 Call ACL to Control HTTP User
Call an ACL to control the WEB NM users.
Cancel the ACL control function.
For more about the commands, refer to the Command Manual.
Note:
Only the numbered basic ACL can be called for WEB NM user control.
Operation
3-6
Chapter 3 Logon User ACL Control Configuration
Command
ip http acl acl-number
undo ip http acl