Call Acl To Control Telnet User; Configuration Example - Huawei Quidway S5000 Series Operation Manual

Operation Manual - QoS/ACL
Quidway S5000 Series Ethernet Switches
Table 3-1 Define basic ACL
Enter basic ACL view(from system view)
add a sub-item to the ACL(from basic ACL view)
delete a sub-item from the ACL(from basic ACL view)
Delete one ACL or all the ACL(from system view)
In the defining process, you can configure several rules for an ACL, using the rule
command repeatedly.

3.2.2 Call ACL to Control TELNET User

To control TELNET users with ACL, you can call the defined ACL in user-interface view.
You can use the following command to call an ACL.
Perform the following configuration in corresponding view.
Table 3-2 Call ACL to Control TELNET User
Enter user-interface view(from system view)
Call an ACL(from user-interface view)
For detailed description of the command, refer to the Command Manual.
Note:
Only the numbered basic ACL can be called for TELNET user control.

3.2.3 Configuration Example

I. Networking requirements
Only permit TELNET user from 10.110.100.52 and 10.110.100.46 access switch.
Operation
Operation
3-2
Chapter 3 Logon User ACL Control Configuration
Command
acl { number acl-number | name acl-name basic }
[ match-order { config | auto } ]
rule [ rule-id ] { permit | deny } [ source source-addr
wildcard | any ] [ fragment ] [ time-range name ]
undo rule rule-id [ source ] [ fragment ] [ time-range ]
undo acl { number acl-number | name acl-name | all }
Command
user-interface [ type ] first-number [ last-number ]
acl acl-number { inbound | outbound }