Maintenance And Troubleshooting; General Maintenance - Furuno PG-700 Operator's Manual

3. MAINTENANCE AND TROUBLE-
SHOOTING
This chapter discusses maintenance and troubleshooting procedures to ensure optimal perfor-
mance of the equipment.
3.1

General Maintenance

To maintain full performance of the equipment, periodic inspection is required. Refer to the follow-
ing table:
Inspection
item
Cable
Check that cable is
securely connected and
there is no rust or corro-
sion.
Ground Ter- Ensure the ground terminal
minal is free of rust and not loose.
Sensor Unit Make sure the unit is free of
dust and dirt.
NOTICE
D
o not apply paint, anti-corrosive
sealant or contact spray to plastic
parts or equipment coating.
Those items contain products that can
damage plastic parts and equipment
coating.
Checkpoint
If necessary, reconnect the cable or replace if dam-
aged.
Tighten the terminal and clean off rust.
Wipe off dust and dirt with a soft, dry cloth. You may
use a cloth moistened with a diluted detergent. Do
not use thinner, acetone, alcohol, benzene, or any
plastic solvent, as they may remove markings from
the panel.
Action
15