Furuno PG-700 Operator's Manual page 19

Key
Short press [+] key
within 5 seconds
Long press [+] key
within 5 seconds
: ON (green)
For example, in the case that the bearing displayed on a instrument connected to the unit is
70°, and the actual bearing is 75°, there is a 5° difference. To set to +5°, press and hold the
[+] key.
3. To exit heading adjustment mode, do not press any key for five seconds. The unit automati-
cally returns to normal status.
Note: Press and hold the [+] and [-] keys for approx. one second at the lamp status after step 1 to
reset to 0.
Correction
value
resets to 0
Normal
condition
Set interval
+0.1°
(increases 0.1°
with every press)
+1.0°
(increases in 1.0°
increments while
key is pressed)
CALIB STATUS
Each lamp flashes
several times
CALIB
STATUS
1. HOW TO INSTALL THE EQUIPMENT
Lamp Status
Each time you press the [+] key, the STATUS lamp
will light on and off.
CALIB
1st time
CALIB
2nd time
CALIB
3rd time
Repeat
CALIB STATUS
: Flashing (green)
CHECK
CHECK
11
STATUS CHECK
STATUS CHECK
STATUS CHECK
CHECK
: OFF
: Flashing (green)
: Flashing (red)
: ON (green)