Teac TN-400S Owner's Manual page 17

Troubleshooting
If you experience a problem with this unit, please check the fol-
lowing items before requesting service. Something other than
this unit could also be the cause of the problem. Please also
check that the connected devices are also being used properly.
If it still does not operate correctly, contact the retailer where
you purchased the unit.
No power.
e Confirm that the AC adapter is plugged into an outlet.
Then, press the STANDBY/ON button to turn the unit on
(pages 14 and 15).
There is no sound.
e When connecting this unit's analog audio output con-
nectors to the audio input connectors of an amplifier
or other equipment, set the PHONO EQ (audio output
setting) switch to ON (page 14).
Playback is not possible; there is noise.
e Raise the protector (page 15).
e Fingerprints and dust on a record can cause noise and
the sound to skip. Use a commercially-available record
cleaner to clean records (page 11).
e Clean the stylus (page 14).
e If the stylus is worn-out, replace it (page 14). The lifespan
of a stylus depends on the use conditions, but it is usually
about 300 hours.
e Place the unit as far away as possible from TVs, micro-
wave ovens and other devices that emit electromagnetic
waves.
Noise occurs when a record is playing.
e Noise could occur if the stylus pressure is higher than
cartridge's specified value. Readjust the stylus pressure so
that it is the specified value (page 12).
The pitch is wrong.
e Select the rotation speed indicated on the record (page
15).
The sound is skipping.
e Vibrations will cause skipping. Place this unit in a stable
location.
e Clean the record.
e Do not use scratched records.
e Balance the tone arm and readjust the stylus pressure
(page 12). The stylus and sound might skip if the stylus
pressure is lower than the cartridge's specified value.
Specifications
Turntable (platter)
Drive system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Belt drive
Motor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . DC motor
Rotation speed. . . . . . . . . . . . . . . . . . . . . 33 1/3 rpm, 45 rpm, 78 rpm
Rotation speed variation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±2%
Wow and flutter. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.2%
SN ratio . . . . . . . . . . . . . . .67 dB or higher (A-weighted, 20 kHz LPF)
Turntable (platter) . . . . . . . . . . . . . . . . . . . . . . . . . . .Aluminum die-cast
30cm (12") diameter
Tone arm
Arm type. . . . . . . . . . . . . . . . . . . Static-balanced S-shaped tone arm
Effective arm length. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 223 mm
Stylus pressure variation range . . . . . . . . . . . . . . . . . . . . . . . . . . . 0–5 g
Acceptable cartridge weight . . . . . . . . . . . . . . . . . . . . . . . . . 4.0–8.0 g
Cartridge
Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . VM (equivalent to MM)
Output voltage. . . . . . . . . . . . . . . . . . . . . . . . . . 4.5 mV (1 kHz, 5 cm/s)
Stylus pressure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.4 ±0.4 g
Cartridge weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.5 ±0.2 g
Included headshell weight
10 g (including screws, nuts and wires)
o The lifespan of a stylus depends on the use conditions but
is usually about 300 hours.
o The cartridge installed in this unit is equivalent to the
Audio-Technica AT100E VM Type cartridge. (The replace-
ment stylus for the installed cartridge is green. It does not
have an Audio-Technica mark.)
Note: VM type cartridges have the same characteristics as
MM type cartridges.
o Replacement stylus model: Audio-Technica ATN100E
Output voltage
PHONO EQ THRU. . . . . . . . . . . . . . . . . . 4.5 mV (1 kHz, 5 cm/s) ±3 dB
PHONO EQ ON . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 230 mV (−13 dBV)
Output connectors. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . RCA
USB port
USB port that can receive power from computer USB buses
(Full Speed) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . USB connector type B
USB bus power support . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 V, 500 mA
Sampling frequency
8 kHz, 11.025 kHz, 16 kHz, 22.05 kHz, 32 kHz, 44.1 kHz, 48 kHz
Quantization bit depth . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16-bit
General
AC adapter power
Input. . . . . . . . . . . . . . . . . . . . . . . . . AC 100 V – AC 240 V, 50–60 Hz
Output. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . DC 12 V, 500 mA
Power consumption
Standby. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0.5 W or less
On (START). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.5 W or less
Weight. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4.9 kg (10 7/8 lb)
Operating temperature range . . . . . . . . . . . . . . . . . . . . . . .5°C to 35°C
Dimensions (W × H × D) (including protrusions)
When the dust cover is closed
420 × 117 × 356 mm (16 5/8" × 4 5/8" × 14 1/8")
When the dust cover is open
420 × 381 × 402 mm (16 5/8" × 15" × 15 7/8")
When the dust cover is removed
420 × 102 × 356 mm (16 5/8" × 4 1/8" × 14 1/8")
o Performance data is specified at 20°C.
Included items
Felt mat × 1
45 RPM adapter × 1
Counterweight × 1
Headshell × 1
Audio-Technica VM Type (dual magnet) stereo cartridge
(equivalent to AT100E) preinstalled
Turntable (platter) × 1
Dust cover × 1
Dust cover hinges × 2
RCA audio cable with grounding terminal × 1
AC adapter (GPE053A-V120050-Z) × 1
Owner's manual (this document) × 1
o Specifications and appearance are subject to change without
notice.
o Weight and dimensions are approximate.
o Illustrations in this owner's manual might differ slightly from
production models.
17