Electrical requirements ......... 5 Range Hood Care ..........13 Location requirements .......... 6 Troubleshooting ........... 15 Product dimensions ..........6 Warranty Information ........... 16 Venting Requirements .......... 7 Prepare the location ..........8 USA 1-800-374-4432 Canada 1-800-265-8352 www.frigidaire.com www.frigidaire.ca 316495194 August 2016...
Serial Number: ______________________________________________________________________________ Purchase Date: ______________________________________________________________________________ NEED HELP? Visit the Frigidaire Web Site at: http://www.frigidaire.com Before you call for service, there are a few things you can do to help us serve you better. Read this manual. It contains instructions to help you use and maintain your range hood properly.
IMPORTANT SAFETY INSTRUCTIONS Read all instructions before using this appliance. Save these instructions for future references WARNING Approved for residential appliances TO REDUCE THE RISK OF FIRE, ELECTRIC For residential use only SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Do not attempt to install or operate your appliance until Use this unit only in the manner intended by the you have read the safety precautions in this manual.
IMPORTANT SAFETY INSTRUCTIONS WARNING WARNING To Reduce The Risk Of Fire Or Electric Shock, Do TO REDUCE THE RISK OF INJURY TO PERSONS, Not Use This Hood With Any External Solid State IN THE EVENT OF A RANGE TOP GREASE FIRE, Speed Control Device.
Electrical Code, Part 1 and C22.2 No. 0-M91 (latest edition) and all local codes and ordinances. NOTE If configuring for recirculation venting, range hood model FHWC3050RS uses recirculation kit FHWRKT30RS and if using range hood model FHWC3650RS recirculation kit FHWRKT36RS would be used. EN-...
VENTING REQUIREMENTS Do not terminate the vent system into an attic or other • Roof Venting Wall Venting enclosed area. Do not use a 4” (10.2 cm) laundry-type wall cap. • Use metal vent only. Rigid metal vent is recommended. •...
VENTING REQUIREMENTS 5/64” drill bit and drill 4 pilot holes as shown PREPARE THE LOCATION for top range hood support. NOTE NOTE: Make the drill holes on the thin area of the slot. Before making cutouts, make sure there is A.
PREPARE THE LOCATION Determine Wiring Hole Location Roof Venting Determine and clearly mark a vertical centerline on To make a 4 ” x 10½” (10.8 cm x 26.7 cm) rectangular ¼ the wall and cabinet bottom. cutout on the underside of cabinet top and bottom: Mark lines (1.6 cm) and 4 ”...
PREPARE THE LOCATION Install Vent System Vent Damper Installation Install vent through the vent opening in upper cabinet Install 3¼” x 10” (8.3 x 25.4 cm) vent damper. or wall. Complete venting system according to the Attach to range hood using the indicated screws selected venting method.
INSTALLING THE HOOD Remove the power supply knockout from the top 1. Disconnect power. or rear of the vent hood (depending on the incoming location of your home power supply cable) and A. White wires install a UL listed or CSA approved ½” strain relief. B.
RANGE HOOD USE RANGE HOOD USE Cleaning The range hood is designed to remove smoke and cook- WARNING ing vapors from the cooktop area. For best results, start the hood before cooking and allow it to operate several To Reduce The Risk Of Fire Or Electrical shock minutes after the cooking is complete to clear all smoke disconnect from power supply before cleaning.
RANGE HOOD CARE To clean or replace grease filter: Push in at the indicated area to open the vent grille. The vent grille will hinge down for access to the grease filters. PUSH TO OPEN Replacing the Front LED lights 1.
RANGE HOOD CARE WARNING Electrical Shock Hax z ard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. Replacing the Rear LED lights 1. Remove the vent grille and grease filters. 2.
TROUBLESHOOTING Problem Possible Causes Solutions After installation, 1. The power line and the cable connector 1. Check the power connections. the unit doesn’t is not connected properly. work. 2. The wires from the switches are disconnected 2. Make sure the wires on the switches are or loose.
Warranty Your appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.