Hitachi DZ-GX20MA Service Manual page 38

Troubleshooting > Messages and Troubleshooting
Message
Disc includes protected
scenes.
Delete scenes?
YES NO
Disc is full.
Cannot add control info.
Disc is not formatted.
Format the disc now?
YES NO
Disc is not formatted.
If it formats, it becomes
possible to use for camera.
However, when you record
from PC connection
terminal, please do not
format.
[Displayed only when DVD-
RW is used]
All data will be deleted.
Select record format.
VR mode VF mode
[Display only when DVD-R
is used]
Format the disc now?
YES NO
Cause/condition for
message to appear
Appears if the loaded disc has a program
(scene) that is write-protected by the
software write-protect function, which is
effective in program units. Although the
DVD video camera/recorder is equipped
with a software disc-protect function that
is effective for disc units, it does not
comply with software write-protect for
program units. (The DVD Forum defines
two types of software protect for DVD-
RAM: disc units and program units.)
Appears when the card contains a scene
write-protected by a device other than
this DVD video camera/recorder.
Appears if the number of scenes on play
list exceeds the upper limit (999) while
control information is being added.
[Refer to *1 page 4-8]
Appears when reading or writing from/to
recorded file cannot be performed
because the disc is dirty.
May appear when a disc formatted and
recorded on a device other than DVD
video camera/recorders is loaded.
Appears when an unformatted DVD-
RAM/DVD-RW or one initialized (other
UDF2.0) on PC is loaded.
Also appears if user rejects partial repair
or total repair of video file.
Appears when a brand-new DVD-RW/
DVD-R was loaded.
*4: The purpose of formatting DVD-R on the DVD video camera/recorder is
to write to disc a program exclusively for camera recording that is
necessary to record images shot by camera in real time (increasing the
response from disc). When recording images that were edited using PC
on DVD-R via the PC connection terminal, do not format the disc: The
program used exclusively for camera recording will disable normal
recording.
4 - 13
Troubleshooting
Release the write-protect using the
device that has the software write-
protect function for program units, or
choose "YES" and designate it to
delete the scenes.
Release the write-protect using the
device which set it. Or choose "YES"
and delete the scene.
Delete any unnecessary scenes, or
combine several scenes, and then
operate the DVD video camera/
recorder.
Refer to "4-4-4 Cleaning disc and
optical pickup" and clean the disc.
Or replace the disc.
Use a PC, etc. to check the contents
on disc.
When initializing it (deleting all
recorded data), choose "YES" and
designate it.
Choose "NO" and designate partial
repair or total repair. When
initializing it (deleting all recorded
data), choose "YES" and designate it.
When recording on the DVD video
camera/recorder, choose "VR Mode/
VF Mode/YES" and designate it.
When recording video edited on PC
connected via the PC connection
terminal, choose "CANCEL/NO" and
designate it.
(*4)