Troubleshooting; Procedure For Troubleshooting - Hitachi DZ-GX20MA Service Manual

4

Troubleshooting

4-1 Procedure for Troubleshooting

Perform troubleshooting in the order shown in Fig. 4-1-1.
Note:
1) Before troubleshooting or servicing, be sure to obtain customer approval for the following:
a) The recorded contents on disc may be lost depending on the details and situation of fault
(defect).
b) The date/time and various settings, including video recording mode, designated by customer
after purchase, may be reset to the defaults before purchase (factory settings).
2) Perform "4-8-2 System reset procedure" after repair is completed: Note that system reset will
erase all error codes that will be necessary for troubleshooting.
3) Take notes of settings on received product in the Remarks and Memo columns, referring to
"Table 4-8-1 List of items to be reset": These notes will be necessary not only for reset, but for
checking any defects that occur under the particular setting conditions.
Check No message
phenomenon appears
Message
appears
Check firmware
version
(section 4-5-1)
Updating
needed
Update firmware
(section 4-5-2)
*1: Messages and error codes will appear on LCD monitor or in viewfinder.
No improvement
Problem guide
(*1)
(section 4-2)
Messages and
(*1) Troubleshooting
(section 4-3)
Updating
unneeded
Trouble
Diagnosis
(section 4-6)
No improvement
after updating
Fig. 4-1-1
4 - 1
Error codes not included in
service manual appear
Display of Error
Codes and
Restriction
(section 4-4)
No improvement
No improvement
Check
troubleshooting
with the factory
Check
troubleshooting
with the factory
: Phenomenon
: Troubleshooting
: Check
: Refer to section
( )