Scheppach FS85000 User Manual page 7

in rotating components. Skid-free shoes are recommen -
ded. Protect long hair with a net.
• Always wear protective goggles (corresponding to ANSI
Z87.1). A normal pair of glasses cannot provide ade
quate protection. In dusty environments, use a face- or
dust mask.
• Never lose your balance. Always remain secure with
both feet planted firmly on the ground.
• Keep your machine in top condition. To achieve the
best and safest output, keep the tools sharp and clean.
Follow the instructions on lubrication and tool change.
• Disconnect the machine from the mains before under -
taking maintenance or adjustment jobs.
• Use recommended spare parts only. Use of tools or ac
cessories not recommended by the dealer can lead to
the risk of physical injury.
• Reduce the risk of unintended activation. Before inser
ting the power plug into the mains socket, please ensu
re that the switch Is in the O position.
• Before working at the machine, please check for dama
ged parts. A damaged protection device or some other
part must be checked carefully to ensure that it is wor
king properly and performing the intended function.
Check the alignment of moving parts, breaking points,
installation or other such conditions that could a ect
the function adversely. A damaged protection device or
some other part must be repaired properly or replaced.
• Do not leave the running machine unsupervised.
Switch o the power supply. Leave the machine only
after it comes to a complete standstill.
• Never work at the machine under the influence of
drugs, alcohol or medicaments.
• Ensure that the machine is disconnected from the
mains when you install, connect or shut down the mo -
tor.
• Tile parts lying around can a ect your health adversely.
Operate the machine at well-ventilated places and en -
sure e ective waste disposal.
• Moving disc can injure operators hands or other body parts .
Before starting work all protection and safety guards must
be installed on the machine.
• Work piece being cut may y o or particles from the
Cuttering process may y o and strike operator. Do Not
cut under size or over size pieces that cannot be held
securely on the cutting table.
•
Wear gloves when changing the cutting discs to avoid
accidentically cutting hands.
•
Never use the machine without the coolant running.
The disc and machiene may over heat and become
dangerours or damaged.
Keep these specifications intact at a safe place.
-
-
-
-
-
-
7