Troubleshooting - Scheppach FS85000 User Manual

Panne
Diamond cutting disc comes off
when motor is deactivated.
when motor is deactivated.
Motor has no output
Trouble shooting
Cause possible
Fastening nut not tightened properly
a) Failure of mains circuit-breaker
b) Extension cable defective
c) Connection with motor or switch is
not OK
d) Motor or switch Is defective
a) Cross-section of the extension cable
Is not sufficient
b) Overloading
Dépannage
Tighten fastening nu
a) Check mains circuit-breaker
b) Replace extension cable
c) Have it checked by an electrician
d) Have it checked by an electrician
a) See electrical connection, the fuse
has blown
b) Check tool
17