Secure Your Wireless Network - TRENDnet TEW-814DAP User Manual

TRENDnet User's Guide
Under This
Setting
Encryption
Strength Low
Open System or
Additional Shared Key,
Options HEX or ASCII,
Different key sizes
Recommended Open System ASCII
Configuration 13 characters
*Dependent on the maximum 802.11n data rate supported by the device (150Mbps,
300Mbps)

Secure your wireless network

Wireless > Basic
After you have determined which security type to use for your wireless network (see
"How to choose the security type for your wireless
wireless security.
Note: By default, your access point is configured with a predefined wireless network
name (SSID) and security key using WPA2-Personal. The predefined wireless network
name and security can be found on the sticker on the side of the access point or on the
device label at the bottom of the access point.
© Copyright 2015 TRENDnet. All Rights Reserved.
Medium High
TKIP or AES, TKIP or AES,
Preshared Key or Preshared Key or
RADIUS RADIUS
TKIP AES
Preshared Key Preshared Key
8-63 characters 8-63 characters
network" on page 10), you can set up
1. Log into your access point management page (see
management page" on page 8).
2. Click on Wireless, and click on Security.
3. Under Wireless Security, click on the Security Mode drop-down list to select your
wireless security type.
Selecting WEP:
If selecting WEP-OPEN or WEP-SHARED (Wired Equivalent Privacy), please review the
WEP settings to configure and click Save Settings to save the changes.
Note: WEP encryption is available when 802.11 n-mode is set to Off, 802.11n does
not support WEP encryption. In addition, when WEP encryption is selected WPS
feature will be disabled.
TEW-814DAP
"Access your access point
10