Fortinet FortiGate 94D PoE User Manual page 7

3. Position the
Note: SFP cage
socket opening and ensure that the
socket orientation
correctly oriented.
may vary. Ensure that
When the
the SFP transceiver
extraction lever
module is correctly
4. Hold the sides of the
oriented each time
the
that you are inserting a
transceiver. Installing
and removing SFP
transceivers can
shorten their useful
life. Do not install or
remove transceivers
more than is
necessary.
Caution: Do not force
the SFP transceivers
into the cage slots. If
5. Press the
the transceiver does
your thumb.
not easily slide in
6. Verify that the
and click into place,
grasping the sides of the transceiver and trying to pull
it may not be aligned
it out without lowering the
correctly or may be
If the transceiver cannot be removed, it is installed
upside down. If this
and latched correctly.
happens, remove
If the transceiver can be removed, reinsert it and
the SFP transceiver,
press harder with your thumb.
realign it or rotate it
If necessary, repeat this process until the
and slide it in again.
is securely latched into the
10
SFP transceiver in front of the cage
transceiver
transceiver is correctly oriented, the
will be level with the socket latch.
SFP transceiver and slide it into
cage socket until it clicks into place.
transceiver cage socket
transceiver is latched correctly by
extraction lever.
transceiver
cage socket.
To remove the SFP transceivers
is
1. Ensure that you are properly grounded.
2. If applicable, disconnect the
a clean dust plug
3. Pull the
open the lever.
4. Hold the sides of the
with
Note:
procedures when
installing and
removing SFP
transceivers to ensure
the devices remain
clean and are not
damaged.
from the
in the transceiver's optical bores.
extraction lever out and down to eject the
transceiver and carefully pull it away from the
Follow proper
5. Replace the cap
the removed SFP transceiver
transceiver connector and install
transceiver. If you are unable to use
screwdriver or other similar tool to
cage socket.
on the SFP cage socket and place
into an antistatic bag.
11