Installing The Kem - Avaya KEM User Manual

Installing the KEM

Use the following instructions to install an IP Deskphone KEM:
1. Remove the IP Phone from the stand by pressing the IP Phone tilt
handle, and pulling the IP Phone away from the stand.
Note: For the IP Phone 2004, you can optionally adjust the stand
angle to maximum, instead of removing the stand.
2. Place the connecting arm of the IP Deskphone KEM behind the IP
Phone and align the IP Deskphone KEM connection plug to the AEM
port on the back of the IP Phone.
Note: An IP Phone 2002 with the product code NTDU76AB34,
NTDU76BB34, NTDU76AB70, or NTDU76BB70 has shorter
connector pins than an IP Phone 2002 with another product code.
If your IP Phone 2002 has a shorter connector pin, you must detach
the ribbon cable connector in the IP Deskphone KEM from the
retaining clip and press the ribbon cable connector into the header
connector before you attach the IP Deskphone KEM.
3. Press the IP Deskphone KEM and IP Phone firmly together until the
IP Phone KEM locks into place.
4. If connecting a second IP Deskphone KEM, repeat steps 2-3.
Note: The second IP Deskphone KEM is attached to the right side of
the first IP Deskphone KEM.
5. Attach the IP Phone stand and the IP Deskphone KEM stand, if
removed. Adjust each IP Deskphone KEM stand to the same angle
as the IP Phone.
The IP Deskphone KEM powers up.
Note: The IP Deskphone KEM uses the electrical connection of the
IP Phone 2002 or IP Phone 2004 for power. It does not have its own
power source.
Setup and assembly
11