Toyotomi CCT 50HINVi Service Manual page 72

3.1.2 RG51C/E
Remote Controller Specifications
Rated Voltage
Lowest Voltage of CPU Emitting Signal
Reaching Distance
Environment Temperature Range
Introduction of Function Buttons on the Remote Controller
Adju st
Mod e sett in g
1. Adjust : Decrease the set temp. Keeping pressing will decrease the temp with 1
2. Adjust : Increase the set temp. Keeping pressing will increase the temp with 1
3. MODE: Once pressing, running mode will be selected in the following sequence:
NOTE: No heating mode for cool only type unit.
4. VERT SWING: Used to stop or start horizontal louver movement. The louver will swing up and down
automatically if push this button.
AIR DIRECTION: Used to set the desired up/down air flow direction. The louver changes 6 degree in
angle for each press.
5. HORIZ SWING: Used to stop or start vertical louver movement.
6. FAN SPEED+ MODE: Press the Mode and Fan speed button simultaneously for 2 seconds. The remote
Electrical Control System
Model
SET TEM PERATURE( C)
AU TO
COOL
DR Y
HE AT
2
MODE
3
SWING
SWING
4
5
AI R
DIRECTI ON
AUTO COOL
8m (when using 3.0 voltage, it can get 11m)
FAN
HIGH
MED
LOW
ADJUST
ON/ O FF
FAN SPEED
TIMER ON
ECO
TI MER OFF
RESET LOC K
DRY
HEAT
RG51C/E
3.0V
2.0V
-5 60
Adj ust
1
ON/ OFF
7
Fan speed se tt ing
8
TI MER ON
9
Econom i c op e rat i o n
10
11
TIME R OFF
12
L ock
Re s et
13
per 0.5s.
per 0.5s.
FAN
Controller
135