Auto-Test And Fault Conditions - Hotpoint MSZ802DF Service Information

Indesit Company
AUTO TEST
This helps with a quick check of the loads and sensors (thermistors), which otherwise are difficult to
activate. NOTE: - Before using the AUTO-TEST it is advisable to check the correct operation of the
temperature 7-segment LEDs (both fridge and freezer display), which are used for signalling possible
malfunctions. Ensure the Super Freeze or Holiday modes have not been selected before starting the
AUTO-TEST.
TO ACTIVATE
STEP 1: If the
appliance has
been connected to
the mains power
for more than 15
minutes,
disconnect it and
wait 40 seconds
before
reconnecting it
back to the mains
supply.
SIDE X SIDE
NO-FROST
STEP 2: Wait until
MODELS
the display
completes its
MSZ801DF
set-up and returns
(cc48862)
to normal
MSZ802DF
operation.
(cc46196)
MSZ803DF
STEP 3: Open the
(cc48863)
freezer door.
MSZ806DF
(cc57217)
STEP 4: Press the
freezer light switch
3 times within 10
seconds.
STEP 5: The test
is activated when
sequence '07'
appears in the
freezer
temperature
display.
Service Manual UK
TO
Sequence of check codes is indicated in
DEACTIVATE the Freezer display
Sequence Code 07:
Evaporator Defrost Heater,
Sequence Code 06:
Fridge Sensor,
Sequence Code 05:
Freezer Sensor,
Sequence Code 04:
Evaporator Fan,
Sequence Code 02 to 00 flashing
alternatively:
Manually:
Baffle/damper triac Q3,
Switching OFF the
Sequence Code 09:
power supply to
Water Valve (Ice Maker),
the appliance.
Sequence Code 12 to 00 flashing
alternatively:
Ice Maker,
Sequence Code 01 to 00 flashing
alternatively:
Water Valve (Washer Dispenser),
NOTE: Confirm by pressing ice water
dispenser pedal,
Sequence Code 00:
END.
NOTE: Auto Test needs to be deactivated
manually. See previous column.
16 of 37
(Sequence Duration)
(3 seconds)
(3 seconds)
(3 seconds)
(3 seconds)
(2.5 minutes)
(3 seconds)
(60 seconds)
English