Servicing & Dismantling Instructions - Hotpoint MSZ802DF Service Information

Indesit Company
SERVICING & DISMANTLING INSTRUCTIONS
Before commencing any work refer to the Safety Notes at the beginning of this manual. All necessary
precautions must be taken to prevent damage to the premises and the appliance. The appliance must
be disconnected from the mains electricity supply. Where necessary, food and containers should be
removed and stored according to the customer's requirements.
A. FREEZER DOOR REMOVAL
1. Remove the lower plinth/grille (2 screws).
2. Disconnect the water tube that enters the bottom of the freezer door from the in-line connector.
3. Remove the top hinge cover (1 hex head screw).
4. Disconnect the 6-pin and 2-pin wiring connectors.
5. Remove 3 hex head screws securing the hinge, whilst supporting the door.
6. Ease the door from the cabinet and lift from the lower hinge without damaging the water tube.
B. FRIDGE DOOR REMOVAL
1. Remove the lower plinth/grille (2 screws).
2. Remove the top hinge cover (1 hex head screw).
3. Remove 3 hex head screws securing the hinge, whilst supporting the door.
4. Ease the door from the cabinet and lift from the lower hinge.
C. DOOR ALIGNMENT/ADJUSTMENT
1. Remove the top hinge cover (1 hex head screw).
2. Loosen the 3 hex head screws securing the hinge.
3. Adjust the alignment using the small adjustment screw.
4. Tighten the 3 hex head screws to secure the hinge.
D. DOOR HANDLES
1. Remove the single screws securing the handle end cap mouldings at each end.
2. Remove the end cap mouldings from the tubular handle grip. These are very tight.
E. ICEMAKER
1. Remove the ice cube bin.
2. Remove the one screw on the underside front of the icemaker.
3. Slide the icemaker forward and away from its support cradle.
4. The connector is embedded in the sidewall at the end of the icemaker; access can be gained after
removing a black sponge block protecting it.
F. AUGER & SOLENOID
1. Remove the ice cube bin and freezer shelving.
2. Remove the 4 screws (1 at each corner) securing the auger motor and solenoid assembly to the
side mouldings.
3. Ease the unit forward and reach in to release the connector from the right hand (DX) sidewall.
Service Manual UK
23 of 37
English