Service Manual Uk - Hotpoint MSZ802DF Service Information

Indesit Company
INSTALLATION INSTRUCTIONS
LEVELLING THE APPLIANCE
The refrigerator has two front and two rear wheels at the base
of the product on each side that can be adjusted (see Figure
A), or four wheels of which only the two front wheels can be
adjusted (see Figure B).
If the appliance seems unsteady or you want the doors to
close easier, adjust the appliance's tilt, following the
instructions below (depending on the model, as shown in the
figures on the right).
1. Check the installation location to be sure you have at least
10 mm clearance on all sides including the top.
2. Connect the appliance to the mains power supply.
3. Move the refrigerator into its final position.
4. Open both doors and remove the plinth to locate the levelling
bolts at the left and right of the refrigerator base. The top bolt
(1) will adjust the rear wheel (if provided), and the bottom bolt
(2) will adjust the front wheel.
5. Use the wrench provided to adjust the levelling bolts. Turn the
levelling bolt clockwise to raise the appliance, or
anti-clockwise to lower it.
It may take several turns of the levelling bolts to adjust the tilt of the refrigerator.
Note: do not unscrew the levelling bolts too much when lowering the appliance as they could
fall out.
Aligning the Doors
If, after switching on the appliance and adjusting the refrigerator and freezer doors, the doors are
misaligned, disconnect the appliance from the power supply and adjust both doors as indicated in the
following diagrams.

Service Manual UK

33 of 37
Figure A
Figure B
English