Hotpoint MSZ802DF Service Information page 24

Indesit Company
G. FREEZER LAMP COVER & LAMP
1. Squeeze the sides inward and down. The front location tab can then be unhooked from its slot.
2. The lamp has two spade terminations and can be pulled out.
H. FREEZER REAR PANELS (EVAPORATOR COVERS)
1. Remove the icemaker as in E and its support cradle.
2. Remove the auger and solenoid assembly as in F.
3. Remove all sidewall runners and fittings (except senor probe cover). Note which way up the
runners are attached to the sidewall.
4. Remove the top section of the rear panel (2 screws).
5. Remove both lower rear panel sections together (6 screws) to expose the evaporator - (foil
insulation behind the sections joins them together). On reassembly, ensure that the foil insulation
is stuck down properly.
J. EVAPORATOR FAN MOTOR
1. Remove the components as in E, F, G, and H.
2. Remove the fan blade.
3. Lift the motor to release the front retaining plastic moulding from its location.
4. Release the rear retaining plastic moulding to release the motor completely.
5. Disconnect the 2-pin connector.
K. FAN MOTOR (Gain access for testing defrost heater, fan motor and cut-out)
1. Remove the 2 bottom screws of the middle rear panel.
2. Using a chisel knife or similar tool ease the bottom edge of the panel away from the foam pad stuck
behind it.
3. Lift the bottom edge forward so the panel is approximately at 45°.
4. Slide the panel forward along the side runners.
5. Disconnect the 2-pin connector for the fan motor.
6. Remove the two screws securing the plastic housing to the rear wall.
7. Lift the assembly from the evaporator metal heat shield.
L. EVAPORATOR
1. Remove the components as in E, F, G, H and K.
2. Lift the evaporator metal heat shield upward slightly to release it from the retaining clip on the rear
wall. Note: It is important to relocate in the clip properly on reassembly.
3. Disconnect the 6-pin connector above the evaporator and the earth connection to the metal heat
shield. Note: Ensure that the earth connection is relocated properly on reassembly.
4. Pull the bottom of the evaporator outward and raise upward to remove the heat shield from the
evaporator. Note: 2 metal clips which are not easy to see, hold the heat shield to the bottom run of
the evaporator. These can fall out as the heat shield is removed.
The metal clips are best refitted as follows:
Before refitting the heat shield, locate the 2 clips correctly in their respective positions inside the heat
shield, toward the bottom. As the heat shield is pushed into place over the evaporator, the clips should
relocate in position on the bottom run of the evaporator tube.
Service Manual UK
24 of 37
continued.....
English