Table of Contents
Advertisement
Installation
Notes on Installing the Camera
The camera body is designed to externally dissipate heat
built up internally during operation.
Install the camera as shown below to promote heat
dissipation and retain optimum performance of the
camera.
• using a suspension support
• using a tripod
• using a metal plate
Note
Do not attach to a board made of wood, resin, etc. that
may block heat dissipation.
Inserting the CompactFlash
1
Loosen the two screws and remove the cover.
2
Press the eject button and insert the CompactFlash
slot.
3
Mount the cover to the camera module, pressing the
CompactFlash slot with the cover inside.
4
Fasten the two screws to secure the cover.
8
Screw
Eject button
Fitting the CS Mount Lens
This camera module supports a C mount lens as the
factory setup. If you will be using a CS mount lens,
perform the following steps:
1
Insert two 3- mm Allen wrenches (commercially
available) through the screw-recess holes of the C
mount adaptor.
2
Turn the Allen wrenches counterclockwise.
3
Remove the C mount adaptor.
If you need to use the C mount adaptor again, follow
steps 1 to 3 in reverse order.
Note
When you fit the C mount adaptor again after removal,
a flange focal length may change. When refitting the
mount, turn the wrenches while applying about 2.5 Nm
of torque.
Advertisement
Table of Contents
