Table of Contents
Advertisement
Once you format the memory card, all the data recorded on the memory card will be deleted and cannot be restored.
Before formatting, copy the data to a computer or other device.
Notes on installation
When installing this product on another device using the tripod screw hole on this product, use a screw less than 5.5
mm (7/32 inches) long (Recommended tightening torque: 2.0 N・m).
When using the fixing (M3) screw holes on this product to secure it, use M3 screws less than 4.5 mm (3/16 inches)
long (Recommended tightening torque: 0.6 N・m).
If you use screws with dimensions other than those specified, you may not be able to secure this product firmly and
may damage it.
Do not install or use this product in a location or on a device that vibrates violently.
Install this product on a flat surface without steps.
Regularly check that the mounting is not loose.
Notes on handling memory cards
The temperature of memory cards may rise after saving. This is not a malfunction.
Backing up memory cards
Data may be corrupted in the following cases. Be sure to back up the data for protection.
When the memory card is removed, the USB cable is disconnected, or the product is turned off in the middle of a
read or write operation.
When the memory card is used in locations subject to static electricity or electrical noise.
Database file error
If you insert a memory card that does not contain an image database file into the product and turn on the power, the
product automatically creates an image database file using some of the memory card's capacity. The process may
take a long time and you cannot operate the product until the process is completed.
If a database file error occurs, export all the data to your computer, etc. to save it, and then format the memory card
using this product.
Do not use/store the product in the following places
In an extremely hot, cold or humid place
In places such as in a car parked in the sun, the camera body may become deformed and this may cause a
malfunction.
Storing under direct sunlight or near a heater
The camera body may become discolored or deformed, and this may cause a malfunction.
In a location subject to rocking vibration
It may cause malfunctions and an inability to record data. In addition, the recording media may become unusable,
and recorded data may be corrupted.
Near strong magnetic place
In sandy or dusty places
Be careful not to let sand or dust get into the product. This may cause the product to malfunction, and in some cases
this malfunction cannot be repaired.
In places with high humidity
This may cause the lens to mold.
In areas where strong radio waves or radiation are being emitted
Recording and playback may not function correctly.
In places where salt damage may occur, or where corrosive gas is emitted
Corrosion of the metal may cause the product to break or fall.
On moisture condensation
15
Advertisement
Table of Contents
