Call Alert Selection; Dual Watch - Midland G5 C User Manual

Call Alert selection

G5 C allows to send a CALL alert signal to all the users of the same channel.
To call, quickly press twice the PTT button. On the display the "TX" icon appe-
ars and the tone of confirmation can be heard by your own speaker.
G5 C has 3 selectable CALL alerts (oF, 1, 2 and 3).
To select, press the MODE button until a "CA" icon with the current CALL
alert number is displayed.
Use the scroll button ▲▼ to make the CALL alert selections; the radio will
emit a corresponding tone for each selection. Note that all this is possible only
if the radio is set on "BP on".
To confirm, press the PTT button or wait for 5 seconds.
To disable this function repeat this procedure selecting "CA of".

Dual Watch

The DUAL WATCH function enables users to monitor, only in reception, 2
selected channels for any activity. To turn on the DUAL WATCH function,
press the MODE button until the display shows "of-TX/RX".
Select the second channel with the scroll buttons ▲▼. If you also want to se-
lect one of the 38 CTCSS tone for the second channel press again the MODE
button and select with ▲▼ the desired tone.
To confirm press the PTT button or wait for 5 seconds.
To turn off the DUAL WATCH function, you can just press the MODE button.
When the radio will receive a signal on one of the two channels selected, the
"DUAL WATCH" function will temporarily stops, allowing the transmission
and the reception of the active signal on the channel in use.
G5 C will stay in the active channel as long as the signal is present and will
resume scanning 5 seconds after the signal is no longer present.
Midland G5 C user manual | 11