Sony MZ-R30 Operating Instructions Manual page 27

MZ-R30 Operating Instructions
BLANKDISC
DISC ERR
DISC FULL
BUSY
NAME FULL
Hi DC in
HOLD
LOW BATT
MEM OVER
NO COPY
NO DISC
NO SIGNAL
PB ONLY
http://www.birst.co.uk/engineering/mzr30/mz-r30e.htm (27 of 32) [16/12/2002 22:59:45]
An MD with no recording on it is inserted.
Insert a recorded MD.
The recorder cannot read the disc (it´s scratchy or dirty).
Reinsert or replace the disc.
There is no more space to record on the disc (less than 12 seconds available).
Replace the disc.
You tried to operate the recorder while it was accessing the recorded data.
Wait until the message goes out (in rare cases, it may take 2.3 minutes).
You tried to enter more than 200 characters for a track or disc name or the total
characters entered in an MD is more than 1700.
Enter the characters within the limit.
Power supply is too high (The supplied AC power adaptor or the recommended car
battery cord is not used).
Use the supplied AC power adaptor or the recommended car battery cord.
The recorder is locked.
Slide HOLD agains the allow to unlick the recorder
Batteries are weak
Charge the rechargeable battery or replace the dry batteries
rechargeable battery, Using on dry
You tried to record when there is no indication in the display, and the recorder is placed
where it receives continuous vibration.
Put the recorder on the stable place, and start recording again.
You tried to make a copy from a disc that is protected by the Serial Copy Management
System. You cannot make copies from a digitally connected source which was itself
recorded using the digital connection.
Use the analog connection instead
You tried to play or record with no disc in the recorder.
Insert an MD.
The recorder could not detect digital input signals.
Make sure that the source is connected firmly
If the error message appears while recording, press
You tried to record or edit on a premastered MD (PB means playback.)
Insert a recordable MD.
(Locking the
batteries).
(Recording an MD right
(Recording with digital
to stop recording.
controls).
(Using on a lithium ion
away!)
input)