Sony MZ-R30 Operating Instructions Manual page 23

MZ-R30 Operating Instructions
recorder. Do not use any other AC power Adaptor since it may cause the recorder to malfunction.
The recorder is not disconnected from the AC power source (mains) as long as it is connected to the wall
outlet, even if the recorder itself has been turned off.
If your are not going to use this recorder for a long time, be sure to disconnect the power supply (AC power
adaptor, dry batteries, rechargeable battery, or car battery cord). To remove the AC power adaptor from the
wall outlet, grasp the adaptor plug itself; never pull the cord.
For use in the car: Use the CPA-9 car connecting pack and the DCC-E260 car battery cord (not supplied).
On heat build-up
Heat may build up in the recorder if it is used for an extended period of time. In this case, leave the recorder
turned off until it cools down.
On installation
Never use the recorder where it will be subjected to extremes of light, temperature, moisture or vibration.
Never wrap the recorder in anything when it is being used with the AC power adaptor. Heat built-up in the
recorder may cause malfunction or damage.
On the headphones
Road safety
Do not use headphones while driving, cycling, or operating any motorized vehicle. It may create a traffic hazard
and is illegal in many areas. It can also be potentially dangerous to play your recorder at high volume while
walking, especially at pedestrian crossings. You should exercise extreme caution or discontinue use in potentially
hazardous situations.
Preventing hearing damage
Avoid using headphones at high volume. Hearing experts advise agains continuous, loud and extended play. If you
experience a ringing in your ears, reduce the volume or discontinue use.
Caring for others
Keep the volume at at moderate level. This will allow you to hear outside sounds and to be considerate of the
people around you.
On the MiniDisc cartridge
Do not break open the shutter
Do not place the cartridge where it will be subject to light, extreme temperatures, moisture or dust.
On cleaning
Clean the recorder casing with a soft cloth slightly moistened with water or a mild detergent solution. Do not
use any type of abrasive pad, scouring powder or solvent such as alcohol or benzene as it may mar the
finish of the casing.
Wipe the disc cartridge with a dry cloth to remove dirt.
Dust on the lens may prevent the unit from operating properly. Be sure to close the disc compartment lid
after inserting and ejecting an MD.
Notes on batteries
Incorrect battery usage may lead to leakage of battery fluid or bursting batteries. To prevent such accidents,
observe the following precautions:
Install the + and - poles of the batteries correctly
Do not install new and used batteries or different kinds o batteries together.
Do not try to recharge dry batteries.
When the recorder is not to be used for a long time, be sure to remove the batteries.
If a battery leak should develop, carefully and thoroughly wipe away battery fluid from the battery
compartment before inserting new ones.
For the customers in Canada
http://www.birst.co.uk/engineering/mzr30/mz-r30e.htm (23 of 32) [16/12/2002 22:59:45]