Table of Contents
Advertisement
Printer Switch Settings
The thermal printer (P/N 1028050) has internal DIP switches that are set at the
factory. For proper operation, these switches must be set as shown in Figure 14
on page 25.
To check and set the switches, perform the following steps:
1
Slide the power switch to the OFF (0) position.
2
Slide the power switch to the ON (I) position while pressing and holding the
ONLINE/OFFLINE button.
3
Release the ONLINE/OFFLINE button after a list of the current settings
(Figure 14 on page 25) begins to print. When the list of settings is complete,
the following prompt appears at the bottom of the printout:
"Continue? : Push On-line SW"
"Write? : Push Paper feed SW"
4
To leave the switch setting the same, push the FEED button.
5
To change any switch settings, push the ONLINE/OFFLINE button. The
prompt "Dip SW-1" appears on the printout below the current settings.
CAUTION: Never turn the printer off while writing the switch set-
tings to memory. When "Dip SW setting complete" is printed, power
may be turned off.
Note: All eight switches in SW-1 must bet set to 'on' or 'off' before
exiting.
6
Set each of the eight switches in Dip SW-1 by pressing the
ONLINE/OFFLINE button="on" or FEED button="off". As ON or OFF is
selected for each switch, the printer prints the selection. When switch 8 is
set, the printer once again prompts to "Continue?" or "Write." Press the
ONLINE/OFFLINE button to continue to SW-2.
7
In the same manner, set the switches for SW-2 and SW-3.
8
When SW-3 is finished, press the FEED button to select "Write." The
changes are written to printer memory, and then the printer returns to on line
mode.
24
Hide quick links:
Advertisement
Table of Contents
