Printing A Report - Sun Nuclear Radon 1028 User Manual

3 Press the ONLINE/OFFLINE button to select off line mode (red LED
illuminated).
4 Push the edge of the paper into the inlet slot at the bottom of the paper
holder until the auto-loader catches and feeds about 10 cm of paper through
the paper cutter.
Note: If the paper is set correctly, the OFFLINE (red) LED will stop
flashing and stay on to indicate the printer is still in off line mode.
5 If necessary, keep pressing the paper FEED button until the paper feeds
straight and smoothly.

Printing a Report

After a test has been performed, it is recommended to print a report before
clearing the data from memory. If there is data in memory when the display is
powered on, the "Data in Memory!" and "Print and Clear" messages appear. Print
a report using the key press options in the table below.
Press... Display Shows...
–
Start Test = 5
Prt=3 Cl=4 Ex=5
+
Compact? Y=5 N=2
Graph?
or
Printing...
or
–
Start Test = 5
Printing can be initiated when the display shows
"Start Test = 5."
Press and hold 3 and 4. Keep holding until the
"Prt=3 Cl=4 Ex=5" message appears.
Press 3 to print (or 5 to exit without printing)
(1029 only).
Press 5 for compact printout; press 2 for stan-
Y=5 N=2
dard printout.
Press 5 to print the bar graph; press 2 to exclude
it. Data is sent to the portable printer.
Printing is complete. A new test can be started.
The data for the test remains in memory and
must be cleared before starting a new test. See
Clearing Memory on page 11.
20
Comment