Scope Of Delivery - Siemens sinamics g120 Operating Instructions Manual

2

Scope of delivery

Scope of delivery
The delivery comprises at least the following components:
● A CU250S-2 Control Unit ready for operation with installed firmware.
Options for upgrading and downgrading the firmware can be found on the Internet:
Firmware (http://support.automation.siemens.com/WW/news/en/67364620)
● Compact Operating Instructions in German and English
● The inverter contains open-source software (OSS). The OSS license terms are saved in
the inverter.
Reading the OSS license terms
The inverter contains open-source software (OSS). OSS comprises open source text and
satisfies special license terms. If you wish to read the license terms, you must transfer them
from the inverter to a PC.
Procedure
To transfer the OSS license terms from the inverter to a PC, proceed as follows:
1. Switch off the inverter power supply.
2. Insert an empty memory card into the card slot of the inverter.
3. Switch on the inverter power supply.
4. When you have switched on the power supply, wait 30 seconds.
During this time, the inverter writes the "Read_OSS.ZIP" file onto the memory card.
5. Switch off the inverter power supply.
6. Withdraw the memory card from the inverter.
7. Use a card reader and load the file to a PC.
You have then transferred the OSS license terms from the inverter to a PC, and you can now
read the license terms.
CU250S-2 Control Units
Compact Operating Instructions, 01/2016, A5E37058195B AA
The fieldbus interface of the Control Unit depends on the order number.
The order number, the designation and the version of the hardware (e.g. 02)
and firmware (e.g. 4.6) can be found on the rating plate
Designation
CU250S-2
CU250S-2 DP
CU250S-2 PN
CU250S-2 CAN
Overview of the interfaces (Page 8)
Order number
6SL3246-0BA22-1BA0
6SL3246-0BA22-1PA0
6SL3246-0BA22-1FA0
6SL3246-0BA22-1CA0
①
of the Control Unit.
Fieldbus
USS, Modbus RTU
PROFIBUS
PROFINET, EtherNet/IP
CANopen
6