Display Assembly - HP Pavilion x360 Maintenance And Service Manual

4. Remove the memory module (2) by pulling it away from the slot at an angle.
Reverse this procedure to install a memory module.

Display assembly

NOTE: The display assembly is spared at the subcomponent level only. For display assembly spare part
information, see the individual removal subsections.
Before removing the display assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation,
turn the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the base enclosure (see
5. Disconnect the battery cable from the system board (see
6. Disconnect the WLAN module antenna cables from the WLAN module (see
7. Remove the system board (see
Remove the display assembly:
1. Remove the five Phillips PM2.5×4.4 screws (1) and the Phillips PM2.0×3.3 screw (2) that secure
the display assembly to the base enclosure.
48 Chapter 5 Removal and replacement procedures
Keyboard/top cover on page
System board on page 40).
28).
Battery on page 33).
WLAN module on page 37).