Service And Storage - Firman P08003 Owner's Manual

Table of Contents

Advertisement

Available languages

Available languages

WARNING
To avoid electric shock:
ALWAYS connect the positive (+) battery cable
(red boot) first when connecting battery cables.
ALWAYS disconnect the negative (-) battery
cable (black boot) first when disconnecting
battery cables.
NEVER connect the negative (-) battery cable
(black boot) to the positive (+) post on the
battery.
NEVER connect the positive (+) battery cable
(red boot) to the negative (-) post on the battery.
NEVER touch both battery posts simultaneously.
NEVER place a metal tool across both battery
posts.
ALWAYS use insulated or nonconducting tools
when installing the battery.
Battery Replacement On Remote
1. Loosening and remove cover screws.
2. Remove the cover.
3. Remove the depleted batteries and insert
two new CR2016 lithium batteries with the
"+" terminal facing up.
4. Close the remote cover and tight the screws.

SERVICE AND STORAGE

Infrequent Service
If the unit is used infrequently, difficult starting
may result. To eliminate hard starting, follow
these instructions:
1. Run the generator at least 30 minutes every
month.
2. Run the generator, then close the fuel shut-off
valve and allow the unit to run until the engine
stops.
3. Move the engine switch to the "OFF" position.
English
Lithium Battery
Long Term Storage
When the generator set is not being operated
or is being stored more than one month, follow
these instructions:
1. Replenish engine oil to upper level.
2. Run the generator, then close the fuel shut-off
valve and allow the unit to run until the engine
stops.
3. Move the engine switch to the "OFF" position.
4. After the unit has cooled, drain gasoline from
fuel tank, fuel line and carburetor.
5. Pour about one teaspoon of engine oil through
the spark plug hole, pull the recoil starter
several times and replace the plug. Then pull
the starter until you feel the piston is on its
compression stroke and leave it in that
position. This closes both the intake and
exhaust valves to prevent the inside of the
cylinder from rusting.
6. Cover the unit and store in a clean, dry place
that is well ventilated away from open flame
or sparks.
NOTE: We recommend always using a fuel
stabilizer. A fuel stabilizer will minimize the
formulation of fuel gum deposits during
storage. The fuel stabilizer can be added to
the gasoline in the fuel tank, or into the
gasoline in a storage container.
NEVER USE WATER TO CLEAN GENERATOR.
Pull starter handle until resistance is felt, leaving
handle in that position.
Store generator in a well ventilated, low humidity
area.
WARNING
Generator exhaust contains odourless and
colourless carbon monoxide gas.
To avoid accidental or unintended ignition of
your generator during periods of storage, the
following precautions should be followed:
When storing the generator for short or
extended periods of time make sure that the
Engine Switch and the Fuel Valve are set in the
OFF position.
Page 27
Customer Service: 1-844-FIRMAN1

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

P05701Po3603P03612

Table of Contents