Advertisement
T u b e l e s s R i m T a p e I n s t a l l a t i o n
Apply the beginning section of tape between the two spoke holes
1
that are 180 degrees opposite from the valve stem hole. Press
4-5 inches (10-13 cm) of tape into the channel of the tire bed.
Apply tension to the tape by rotating the wheel away from you while
2
rapidly shaking the tape from side to side about 2-3 inches (5-8 cm).
This will seat the tape into the channel and keep it centered in the rim.
NOTI CE
The tubeless tape must be seated into the rim bed to create an air tight
seal. If the tape is not seated into the channel, the tire may leak air.
Continue the process of rotating the wheel and shaking the tape
3
side to side while keeping an even tension on the tape roll until
the tape has been wrapped around the rim bed twice. Overlap the
beginning edge with another 12 inches (31 cm) of tape to the rim bed.
5
Tubeless Rim Tape Installation
Advertisement
