TASKalfa 3011i Operation Manual page 290

Using Various Functions > Functions
NOTE
One position staple is not slanted for the following paper sizes.
B5-R, 16K-R
Mixed Size Stapling
Even with mixed paper sizes, if the sizes have the same width as shown in the combinations below, the output can be
stapled.
• A3 and A4
• B4 and B5
• Ledger and Letter
• Ledger and Letter-R
• 8K and 16K
NOTE
• Number of sheets that can be stapled: up to 30 sheets.
• When performing Mixed Size Stapling, refer to the following:
Mixed Size Originals (page 6-20)
Punch
Punches holes in sets of finished documents.
NOTE
• This function requires the optional Document Finisher and Punch Unit.
• For details on paper sizes that can be punched, refer to the following:
Punch Unit (For 1,000-Sheet/3,000-Sheet Finisher) (page 11-25)
• The inch model provides two-hole and three-hole punching. The metric model provides two-hole and four-hole
punching.
Item
Punch Off
2 holes Left
2 holes Top
2 holes Right
3 holes Left
3 holes Top
3 holes Right
4 holes Left
4 holes Top
4 holes Right
Original Top Edge on Top,
Orientation Top Edge on Left,
Auto
*1 This function can only be used when the optional OCR Scan Activation Kit is installed.
Value
Select the position of punch holes. For details on original orientation and
position of punch holes, refer to the following:
Original Orientation and Punch Hole Position (page 6-27)
Select the orientation of the original document top edge to scan correct
direction. Select [Original Orientation] to choose orientation of the
*1
originals, either [Top Edge on Top] or [Top Edge on Left]. Then select
[OK].
A4 A3
B5 B4
Letter Ledger
A4 A3
B5 B4
Letter Ledger
Letter-R Legal
Letter-R Legal
Description
6-26