Advertisement
English
Install the car audio
These instructions are for a typical installation.
However, if your car has different requirements,
make the corresponding adjustment. If you have
any questions regarding installation kits, consult
your Philips car audio dealer.
Caution
This unit is designed for negative ground
(earth) 12 V DC operation only.
Always install this unit in the car dashboard.
Other locations can be dangerous as the
rear of the unit heats up during use.
To avoid short-circuit: before you connect,
ensure that the ignition is off.
Ensure that you connect the yellow and red
power supply leads after all other leads are
connected.
Ensure that all loose leads are insulated with
electrical tape.
Ensure that the leads do not get caught
under screws orin parts that will move
(e.g. seat rail).
Ensure that all ground (earth) leads are run
to a common ground (earth) point.
Use only the supplied mounting hardware
for a safe and secure installation.
When you need to change the fuse, consult
a professional.
Connect wires
1
Caution
Ensure that all loose leads are insulated with
electrical tape.
1
Check the car's wiring carefully, then connect
them to the two supplied ISO wires.
1
2
3
4
5
6
7
8
9
10 Purple and
2
3
a
Connector Connect to
Brown wire Telephone mute
Red wire
The +12V power terminal
which is live in the accessory
(ACC) position of the
ignition switch
If there is no accessory
position, connect to the
+12V car battery terminal
that is always live. Be sure
to connect the black ground
(earth) lead to a metal surface
Orange wire Illumination switch
Black wire
A metal surface of the car
First connect the black
ground (earth) lead, then
connect the yellow and red
power supply leads.
Yellow wire The +12V car battery which
is live at all times.
Blue wire
The electric antenna control
lead or power supply lead of
the antenna booster
If there is no electric antenna
or antenna booster, or it is
manually operated telescopic
antenna, it is not necessary
to connect this lead.
Green and
Left speaker (Rear)
green/black
wires
White and
Left speaker (Front)
white/black
wires
Gray and
Right speaker (Front)
gray/black
wires
Right speaker (Rear)
purple/black
wires
Connect the other end of the two ISO
connectors to the car audio system.
If necessary, do the other connections:
b
c
Advertisement
