Install The Car Audio; Connect Wires - Philips CED1700/51 Quick Start Manual

English

Install the car audio

These instructions are for a typical installation.
However, if your car has different requirements,
make the corresponding adjustment. If you have
any questions regarding installation kits, consult
your Philips car audio dealer.

Connect wires

1
1
Check the car's wiring carefully, then connect
them to the supplied ISO wires.
Connector Connect to
Yellow wire The +12V car battery which
1
is live at all times.
2 Blue wire The electric antenna control
lead or power supply lead of
the antenna booster
If there is no electric antenna
or antenna booster, or it is
manually operated telescopic
antenna, it is not necessary
to connect this lead.
A metal surface of the car
3 Black wire
First connect the black
ground (earth) lead, then
connect the yellow and red
power supply leads.
The +12V power terminal
4 Red wire
which is live in the accessory
(ACC) position of the
ignition switch
If there is no accessory
position, connect to the
+12V car battery terminal
that is always live. Be sure
to connect the black ground
(earth) lead to a metal
surface of the car first.
5 Green and Left speaker (Rear)
green/black
wires
Left speaker (Front)
6 White and
white/black
wires
7 Gray and Right speaker (Front)
gray/black
wires
a
Connector Connect to
Right speaker (Rear)
8 Purple and
purple/black
wires
2
Connect the other end of the supplied
standard connector to the car audio
system.
b
Connector/
Obeject
1 Pink wire
2 2.5m extension
wire (Not included)
3 Brake switch
4 Ground
5 ISO wires
6 Grey wire
7 Black wire
8 Blue cable
9 Red cable
10 White cable
11 Yellow cable
12 Yellow cable
13 Yellow cable
14 Yellow cable
15 Purple wire
16 Gearbox switch
17 Reverse gear signal Back lamp lead +
Mount in the dashboard
1
If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
2
Ensure that car dashboard opening is within
these measurements:
3
Slide the unit into the dashboard until a
click sound is heard.
4
Attach the trim plate.
5
Reconnect the negative terminal of the car
battery.
Connect to/with
Extension wire
Parking brake (-)
Connected in step 1
above.
Rear line out Left/
Right
Front line out Left/
Right
Subwoofer
Aux Right
Aux Left
Video in
Camera in
Video out 1
Video out 2
Reverse camera (B+)
2
a
b
c