Adjustment Procedures; Replacement Of Mechanical Parts; Cabinet Replacement; Top Panel And Top Cover - Toshiba HD-XA1KN Service Manual

PART REPLACEMENT AND

ADJUSTMENT PROCEDURES

CAUTIONS BEFORE STARTING PART REPLACEMENT
Electronic parts are susceptible to static electricity and may be easily damaged, so do not forget to ground as required.
Many screws are used inside the unit. To prevent the screws from missing or dropping, etc. always use magnetized
screwdriver in servicing. Several kinds of screws are used and some of them need special cautions. That is, take care of
the tapping screws securing molded parts and fine pitch screws used to secure metal parts. If they are used improperly,
the screw holes will be easily damaged and the parts can not be fixed.
This section describes how to replace the parts of HD-XA1 as a representative.

1. REPLACEMENT OF MECHANICAL PARTS

1-1. Cabinet Replacement

1-1-1. Top Panel and Top Cover

1. Remove two screws (1), then remove the side panel L (2) and side panel R (3).
2. Remove three screws (4), then remove the top panel (5).
3. Remove four screws (6), then remove the top cover (7).
Top panel (5)
Side panel L (2)
Screws (6)
Top cover (7)
SECTION 2
Screws (1)
Gasket
Gasket
Fig. 2-1-1
Screws (4)
Screws (6)
Screws (1)
Side panel R (3)